NSPS for Stationary Gas
Turbines (40 CFR Part 60, Subpart GG) (Renewal)
Extension without change of a currently approved collection
No
Regular
09/30/2025
Requested
Previously Approved
36 Months From Approved
09/30/2025
1,070
1,070
69,100
69,100
0
0
The New Source Performance Standards
(NSPS) for Stationary Gas Turbines (40 CFR Part 60, Subpart GG)
were promulgated on September 10, 1979; and last-amended on
February 27, 2014. These regulations apply to both existing
facilities and new facilities that have stationary gas turbines
with a heat input at peak load equal or greater than 10.7
gigajoules per hour (based on the lower heating value of the fuel
fired). There are no new facilities under this subpart, as any
facility which commenced either construction, or modification, or
reconstruction after February 18, 2005 is subject to the NSPS for
Stationary Combustion Turbines (40 CFR Part 60, Subpart KKKK). This
information is being collected to assure compliance with 40 CFR
Part 60, Subpart GG. In general, all NSPS standards require initial
notifications, performance tests, and periodic reports by the
owners/operators of the affected facilities. They are also required
to maintain records of the occurrence and duration of any startup,
shutdown, or malfunction in the operation of an affected facility,
or any period during which the monitoring system is inoperative.
These notifications, reports, and records are essential in
determining compliance, and are required of all affected facilities
subject to NSPS.
On behalf of this Federal agency, I certify that
the collection of information encompassed by this request complies
with 5 CFR 1320.9 and the related provisions of 5 CFR
1320.8(b)(3).
The following is a summary of the topics, regarding
the proposed collection of information, that the certification
covers:
(i) Why the information is being collected;
(ii) Use of information;
(iii) Burden estimate;
(iv) Nature of response (voluntary, required for a
benefit, or mandatory);
(v) Nature and extent of confidentiality; and
(vi) Need to display currently valid OMB control
number;
If you are unable to certify compliance with any of
these provisions, identify the item by leaving the box unchecked
and explain the reason in the Supporting Statement.