Published 60 Day FRN

jbell on DSK30RV082PROD with NOTICES

Federal Register / Vol. 84, No. 58 / Tuesday, March 26, 2019 / Notices
harnesses; and, light assemblies (duty
rate ranges from duty-free to 8.5%).
Whirlpool would be able to avoid duty
on foreign-status components which
become scrap/waste. Customs duties
also could possibly be deferred or
reduced on foreign-status production
equipment.
The components and materials
sourced from abroad include: Plastic fill
hoses; plastic tape; plastic labels; plastic
self-adhesive seals; plastic foam seals;
plastic reinforced seals; plastic nuts;
plastic cable ties; rubber hoses; rubber
gaskets; rubber grommets; steel screws;
steel nuts; steel helical springs; steel
hose clamps; steel latch plates; brass
washers; threaded brass inserts;
centrifugal pumps; air filters; inner and
outer doors; front exterior panels;
hinges; spray arms; detergent
dispensers; dish rack tracks and mounts;
plastic rack wheels; steel wire dish
racks; chassis tubs; plastic grommets; lid
gaskets; manifolds; solenoid valves;
control valves; valve housings;
gearboxes; pinion gears; worm gears;
bevel gears; synchronous motors;
universal AC/DC motors; DC motors;
single and multi-phase AC motors; fixed
capacitors; dielectric fixed capacitors;
fuses; relays; overload protectors;
grounding tabs; control panels/user
interfaces; consoles; printed circuit
assemblies; plastic buttons; LED lamps;
wire harnesses; and, internal light
fittings (duty rate ranges from duty-free
to 8.5%). The request indicates that
certain materials/components are
subject to special duties under Section
301 of the Trade Act of 1974 (Section
301), depending on the country of
origin. The applicable Section 301
decisions require subject merchandise
to be admitted to FTZs in privileged
foreign status (19 CFR 146.41).
Public comment is invited from
interested parties. Submissions shall be
addressed to the Board’s Executive
Secretary at the address below. The
closing period for their receipt is May 6,
2019.
A copy of the notification will be
available for public inspection at the
Office of the Executive Secretary,
Foreign-Trade Zones Board, Room
21013, U.S. Department of Commerce,
1401 Constitution Avenue NW,
Washington, DC 20230–0002, and in the
‘‘Reading Room’’ section of the Board’s
website, which is accessible via
www.trade.gov/ftz.
For further information, contact
Elizabeth Whiteman at
Elizabeth.Whiteman@trade.gov or (202)
482–0473.

VerDate Sep<11>2014

17:54 Mar 25, 2019

Jkt 247001

11283

Dated: March 20, 2019.
Andrew McGilvray,
Executive Secretary.

DEPARTMENT OF COMMERCE

[FR Doc. 2019–05733 Filed 3–25–19; 8:45 am]

Proposed Information Collection;
Comment Request; Interim Procedures
for Considering Requests Under the
Commercial Availability Provision of
the United States-Panama Trade
Promotion Agreement (U.S.-Panama
TPA)

International Trade Administration

BILLING CODE 3510–DS–P

DEPARTMENT OF COMMERCE
Foreign-Trade Zones Board

Foreign-Trade Zone (FTZ) 119—
Minneapolis-St. Paul, Minnesota;
Authorization of Production Activity;
AGCO Corporation; Subzone 119M;
(Agricultural Equipment and Related
Subassemblies and Components);
Jackson and Round Lake, Minnesota
On October 11, 2018, AGCO
Corporation, operator of Subzone 119M,
submitted a notification of proposed
production activity to the FTZ Board for
its facility within Subzone 119M, in
Jackson and Round Lake, Minnesota.
The notification was processed in
accordance with the regulations of the
FTZ Board (15 CFR part 400), including
notice in the Federal Register inviting
public comment (83 FR 54314–54315,
October 29, 2018). On March 20, 2019,
the applicant was notified of the FTZ
Board’s decision that no further review
of the activity is warranted at this time.
The production activity described in the
notification was authorized, subject to
the FTZ Act and the FTZ Board’s
regulations, including Section 400.14.
The authorization was further subject to
a restriction requiring that textilereinforced rubber hoses, textilereinforced rubber conveyor belts,
textile-reinforced rubber transmission
belts, gaskets of textile materials, textile
sound absorbers, safety belts of fabric,
fabric-reinforced cab isolators,
headliners incorporating fabric,
windscreens of fabric, sound
suppressors incorporating fabric, sun
visors of fabric, and seats with fabric
surfaces be admitted to the subzone in
privileged foreign status (19 CFR
146.41).
Dated: March 20, 2019.
Andrew McGilvray,
Executive Secretary.
[FR Doc. 2019–05731 Filed 3–25–19; 8:45 am]
BILLING CODE 3510–DS–P

PO 00000

Frm 00005

International Trade
Administration.
ACTION: Notice.
AGENCY:

[B–64–2018]

Fmt 4703

Sfmt 4703

SUMMARY: On behalf of the Committee
for the Implementation of Textile
Agreements (CITA), the Department of
Commerce, as part of its continuing
effort to reduce paperwork and
respondent burden, invites the general
public and other Federal agencies to
take this opportunity to comment on
proposed and/or continuing information
collections, as required by the
Paperwork Reduction Act of 1995.
DATES: Written comments must be
submitted on or before May 28, 2019.
ADDRESSES: Direct all written comments
to Jennifer Jessup, Departmental
Paperwork Clearance Officer,
Department of Commerce, Room 6616,
14th and Constitution Avenue NW,
Washington, DC 20230 (or via the
internet at PRAcomments@doc.gov).
FOR FURTHER INFORMATION CONTACT:
Requests for additional information or
copies of the information collection
instrument and instructions should be
directed to Laurie Mease, Office of
Textiles and Apparel, Telephone: 202–
482–2043, Email: Laurie.Mease@
trade.gov.
SUPPLEMENTARY INFORMATION:

I. Abstract
Title II, Section 203(o) of the United
States-Panama Trade Promotion
Agreement Implementation Act (the
‘‘Act’’) [Pub. L. 112–43] implements the
commercial availability provision
provided for in Article 3.25 of the
United States-Panama Trade Promotion
Agreement (the ‘‘Agreement’’). The
Agreement entered into force on
October 31, 2012. Subject to the rules of
origin in Annex 4.1 of the Agreement,
pursuant to the textile provisions of the
Agreement, fabric, yarn, and fiber
produced in Panama or the United
States and traded between the two
countries are entitled to duty-free tariff
treatment. Annex 3.25 of the Agreement
also lists specific fabrics, yarns, and
fibers that the two countries agreed are
not available in commercial quantities
in a timely manner from producers in
Panama or the United States. The items

E:\FR\FM\26MRN1.SGM

26MRN1

jbell on DSK30RV082PROD with NOTICES

11284

Federal Register / Vol. 84, No. 58 / Tuesday, March 26, 2019 / Notices

listed in Annex 3.25 are commercially
unavailable fabrics, yarns, and fibers.
Articles containing these items are
entitled to duty-free or preferential
treatment despite containing inputs not
produced in Panama or the United
States.
The list of commercially unavailable
fabrics, yarns, and fibers may be
changed pursuant to the commercial
availability provision in Chapter 3,
Article 3.25, Paragraphs 4–6 of the
Agreement. Under this provision,
interested entities from Panama or the
United States have the right to request
that a specific fabric, yarn, or fiber be
added to, or removed from, the list of
commercially unavailable fabrics, yarns,
and fibers in Annex 3.25 of the
Agreement.
Pursuant to Chapter 3, Article 3.25,
paragraph 6 of the Agreement, which
requires that the President publish
procedures for parties to exercise the
right to make these requests, Section
203(o)(4) of the Act authorizes the
President to establish procedures to
modify the list of fabrics, yarns, or fibers
not available in commercial quantities
in a timely manner in either the United
States or Panama as set out in Annex
3.25 of the Agreement. The President
delegated the responsibility for
publishing the procedures and
administering commercial availability
requests to the Committee for the
Implementation of Textile Agreements
(‘‘CITA’’), which issues procedures and
acts on requests through the U.S.
Department of Commerce, Office of
Textiles and Apparel (‘‘OTEXA’’) (See
Proclamation No. 8894, 77 FR 66507,
November 5, 2012).
The intent of the U.S.-Panama TPA
Commercial Availability Procedures is
to foster the use of U.S. and regional
products by implementing procedures
that allow products to be placed on or
removed from a product list, on a timely
basis, and in a manner that is consistent
with normal business practice. The
procedures are intended to facilitate the
transmission of requests; allow the
market to indicate the availability of the
supply of products that are the subject
of requests; make available promptly, to
interested entities and the public,
information regarding the requests for
products and offers received for those
products; ensure wide participation by
interested entities and parties; allow for
careful review and consideration of
information provided to substantiate
requests and responses; and provide
timely public dissemination of
information used by CITA in making
commercial availability determinations.
CITA must collect certain information
about fabric, yarn, or fiber technical

VerDate Sep<11>2014

17:54 Mar 25, 2019

Jkt 247001

specifications and the production
capabilities of Panamanian and U.S.
textile producers to determine whether
certain fabrics, yarns, or fibers are
available in commercial quantities in a
timely manner in the United States or
Panama, subject to Section 203(o) of the
Act.
II. Method of Collection
Participants in a commercial
availability proceeding must submit
public versions of their Requests,
Responses or Rebuttals electronically
(via email) for posting on OTEXA’s
website. Confidential versions of those
submissions which contain business
confidential information must be
delivered in hard copy to the Office of
Textiles and Apparel (OTEXA) at the
U.S. Department of Commerce.
III. Data
OMB Control Number: 0625–0273.
Form Number(s): N/A.
Type of Review: Regular submission.
Affected Public: Business or for-profit
organizations.
Estimated Number of Respondents:
16.
Estimated Time per Response: 8 hours
per Request, 2 hours per Response, and
1 hour per Rebuttal.
Estimated Total Annual Burden
Hours: 89.
Estimated Total Annual Cost to
Public: $5,340.
IV. Request for Comments
Comments are invited on: (a) Whether
the proposed collection of information
is necessary for the proper performance
of the functions of the agency, including
whether the information shall have
practical utility; (b) the accuracy of the
agency’s estimate of the burden
(including hours and cost) of the
proposed collection of information; (c)
ways to enhance the quality, utility, and
clarity of the information to be
collected; and (d) ways to minimize the
burden of the collection of information
on respondents, including through the
use of automated collection techniques
or other forms of information
technology.
Comments submitted in response to
this notice will be summarized and/or
included in the request for OMB
approval of this information collection;
they also will become a matter of public
record.
Sheleen Dumas,
Departmental Lead PRA Officer, Office of the
Chief Information Officer, Commerce
Department.
[FR Doc. 2019–05749 Filed 3–25–19; 8:45 am]
BILLING CODE 3510–DS–P

PO 00000

Frm 00006

Fmt 4703

Sfmt 4703

DEPARTMENT OF COMMERCE
International Trade Administration
[A–583–853]

Certain Crystalline Silicon Photovoltaic
Products From Taiwan: Initiation of
Antidumping Duty Changed
Circumstances Review
Enforcement and Compliance,
International Trade Administration,
Department of Commerce.
SUMMARY: The Department of Commerce
(Commerce) is initiating a changed
circumstances review to determine if
United Renewable Energy Co., Ltd.
(URE) is the successor-in-interest to Neo
Solar Power Corporation (NSP), Gintech
Energy Corporation (Gintech), and
Solartech Energy Corporation
(Solartech) in the context of the
antidumping duty order on certain
crystalline silicon photovoltaic products
(solar products) from Taiwan.
DATES: Applicable March 26, 2019.
FOR FURTHER INFORMATION CONTACT:
Robert Galantucci, AD/CVD Operations,
Office IV, Enforcement and Compliance,
International Trade Administration,
U.S. Department of Commerce, 1401
Constitution Avenue NW, Washington,
DC 20230; telephone: 202–482–2923.
SUPPLEMENTARY INFORMATION:
AGENCY:

Background
On February 18, 2015, Commerce
published in the Federal Register an
antidumping duty order on solar
products from Taiwan.1 On February 1,
2019, URE requested that, pursuant to
section 751(b)(1) of the Tariff Act of
1930, as amended (the Act) and 19 CFR
351.216(b), Commerce conduct an
expedited changed circumstances
review of the Order to determine that
URE is the successor-in-interest to NSP,
Gintech and Solartech, and accordingly,
to assign URE the cash deposit rate
assigned to the three predecessor
companies in the second administrative
review.2
Scope of the Order
The merchandise covered by this
Order is crystalline silicon photovoltaic
cells, and modules, laminates and/or
1 See Certain Crystalline Silicon Photovoltaic
Products from Taiwan: Antidumping Duty Order,
80 FR 8596 (February 18, 2015) (Order).
2 See Letter, ‘‘Certain Crystalline Silicon
Photovoltaic Products from Taiwan: Request for
Changed Circumstances Review and Successor-inInterest Determination,’’ dated February 1, 2019
(CCR Request) at 2; see also Certain Crystalline
Silicon Photovoltaic Products from Taiwan: Final
Results of Antidumping Duty Administrative
Review; 2016–2017, 83 FR 30401 (June 28, 2018)
(AR2 Final Results).

E:\FR\FM\26MRN1.SGM

26MRN1