Analysis of Exoskeleton-Use for Enhancing Human Performance to Complete Industrial Tasks

Survey Questions (pg 1)
Exoskeleton Study

OMB Control #0693-XXXX
Expiration Date: XX/XX/XXXX

Pre-Test

Before putting on the exoskeleton, have you had any previous injuries or do you have any
current pain, soreness or discomfort that may affect how you perform the test? Please
write the number(s) and mark the severity or write “none”.

Test Preparation

1. On a scale from 0 - 5 (no effort – extreme effort), I found that to put on the exoskeleton
included:
0
No Effort

1

2

3

4

5
Extreme Effort

2. On a scale from 0 - 5 (uncomfortable - very comfortable), I found that the exoskeleton was:
0
Uncomfortable

1

2

3

4

5
Very Comfortable

Pre Test
Movement

Survey Questions (pg 2)
Exoskeleton Study
3. While initially wearing the exoskeleton, I found that my movements were:
0
Not
Obstructed

1

2

3

4

5
Obstructed

During the Test

4. During the test, did you have any pain, soreness or discomfort? Please mark
accordingly.

5. The exoskeleton provided ergonomic (efficient and comfortable) support
during the test.
0
1
2
3
4
5
N/A Strongly Disagree
Disagree
Neutral
Agree
Strongly Agree
6. While wearing the exoskeleton, it helped you complete the test?
0
1
2
3
4
5
N/A Strongly Disagree
Disagree
Neutral
Agree
Strongly Agree
7. The task you performed provided information about the usefulness of an
exoskeleton.
0
1
2
3
4
5
N/A Strongly Disagree
Disagree
Neutral
Agree
Strongly Agree

Survey Questions (pg 3)
Exoskeleton Study
8. Was the task you performed frustrating to you?
Yes

No

General Questions about the Test

9. What did you like most and least about wearing and using the exoskeleton?
Most liked: ____________________________________________________________
______________________________________________________________________
Least liked: ____________________________________________________________
______________________________________________________________________
10. Where did you feel the exoskeleton best supported your movements during the
task (knees, hips, back, shoulders, arms, etc.) ?
_______________________________________________________________________
_____________________________________________________________________
11. What were the easiest and most difficult parts of the exoskeleton test(s)?
Easiest: ______________________________________________________________
Most Difficult: _________________________________________________________
12. What would you change about the exoskeleton or the task you performed (use the
back of this page if more space is needed)?
_______________________________________________________________________
_______________________________________________________________________
13. The task sufficiently captured my maximum load and repetition without the
exoskeleton.
0
1
2
3
4
5
N/A Strongly Disagree
Disagree
Neutral
Agree
Strongly Agree
14. The task sufficiently captured my maximum load and repetition with the
exoskeleton.
0
1
2
3
4
5
N/A Strongly Disagree
Disagree
Neutral
Agree
Strongly Agree
15. The test properly represents the real world.
0
1
2
3
N/A Strongly Disagree
Disagree
Neutral

4
Agree

5
Strongly Agree

16. The task tested the limitations of the exoskeleton.
0
1
2
3
4
5
N/A Strongly Disagree Neutral Agree
Strongly
Disagree
Agree
17. The task tested the capabilities of the exoskeleton.
0
1
2
3
4
5
N/A Strongly Disagree Neutral Agree
Strongly
Disagree
Agree

This collection of information contains Paperwork Reduction Act (PRA) requirements approved
by the Office of Management and Budget (OMB). Notwithstanding any other provisions of the
law, no person is required to respond to, nor shall any person be subject to a penalty for failure to
comply with, a collection of information subject to the requirements of the PRA unless that
collection of information displays a currently valid OMB control number. Public reporting
burden for this collection is estimated to be 10 minutes per response, including the time for
reviewing instructions, searching existing data sources, gathering and maintaining the data
needed and completing and reviewing the collection of information. Send comments regarding
this burden estimate or any aspect of this collection of information, including suggestions for
reducing this burden, to the National Institute of Standards and Technology, Attn: Roger
Bostelman at roger.bostelman@nist.gov.